Posted 17 Sep 2021 Hi, We have an old Quick Panel 2 that is communicating with a CTC 2700 PLC. I have tried uploading the program from the Quick Panel 2 using Proficy ME 9.0 and Quick Designer 3.7, but I get an error that it doesn't support CTC Binary protocol. When using Quick Designer 3.7, I get a similar message about unsupported communication protocol. Does anybody know anything about the CTC Binary communication driver? Is this in a different version of Quick Designer? Any help is greatly appreciated. Thanks, Don Share this post Link to post Share on other sites
Posted 17 Sep 2021 I have Quick Designer version 3.4 installed on an XP virtual machine. When I start a new project the CTC binary protocol is not among the options. My experience with the Quick Panel product line is from after they were acquired by GE. Perhaps GE did not include full support for Total Control Product's entire suite of communications protocols when they bought them. Have you tried contacting Proface? They may have better support for the vintage QP lineup. Note: I composed this response after I replied to your private message at PLCTalk.net Share this post Link to post Share on other sites