Posted 13 Aug 2021 Hey folksI'm trying to make a Ladder program in Sysmac Studio to control a Crane.The crane gets via a HMI a position that it must drive to, first at high speed then in low speed this is controlled via encoder signal for fine positioning there are several sensors.For all this I have an NX1P2-9B24DT1, NX-EC0222 and 3G3MX2-A4030-ESomeone here who can help me with an example of how this can be done in Ladder.Many thanks in advance for your help. Share this post Link to post Share on other sites
Posted 13 Aug 2021 Nobody is going to write your program for you for free. If you post what you have put together, they will give you advice on it though. What have you done so far? Share this post Link to post Share on other sites