Posted 16 Jul 2021 I believe that conversion is possible, but have no idea how? Share this post Link to post Share on other sites
Posted 16 Jul 2021 just read the project. Open other project .... Share this post Link to post Share on other sites
Posted 20 Jul 2021 Hi Gambit, I've tried that. I selected the "Open other data", then "Open other project". The selected "SOFTCTRL.PRO" in the project file. Result: PLC type of this project is not supported by this function. Cannot open the project. I should have mentioned that the PLC in question is an A2AS-s30. I've uploaded the file. Maybe there is some voodoo you can think of. I tried converting to Q series in IEC Developer. Tons of errors . PLC1 2021_06_22.PCD Share this post Link to post Share on other sites
Posted 20 Jul 2021 aha I see. That's right A series PLC can only be programmed with GX and GX IEC Developer. However you should be able to convert to System Q and than import into GX 2 Share this post Link to post Share on other sites
Posted 20 Jul 2021 I have taken a small look at your project. after you've changed to a system Q you will need to define File registers and there are three label with an special adres M9036 => SM400 M9038 => SM402 These are also programmed directly in your program instead of labels. you will need to change those as well. There are also some very old LED instructions which can be converted to simple dedicated instructions. But this has to be done manually. Share this post Link to post Share on other sites
Posted 20 Jul 2021 Thanks a ton Gambit. Will proceed as suggested. :) Share this post Link to post Share on other sites