Basit Jamil

Intelligent Functional Module Stop Working

8 posts in this topic

Hi, I am facing the strange problem with QCPU (Q03UDE) Controller, I have multiple modules in my project ( Analog, Modbus & Digital Modules) but after some time a random error comes and all my analog Chanel values hold the last values, meanwhile controller does not show any error in the diagnostic tool. After rebooting the PLC power Chanel values start to update. This thing happens randomly. 

Kindly help me. 

Thanks in advance

Share this post


Link to post
Share on other sites

check the modules error not the CPU. use the system monitor

Share this post


Link to post
Share on other sites

There is no error on the module.And in system monitor i also checked the error but there is no error there.

Share this post


Link to post
Share on other sites

and when you monitor the values on the BFM and the X/Y off the cards  ?

Share this post


Link to post
Share on other sites

The values on the BFM hold its values.

X and Y of Analog Input Module is as follows.

Module Ready X is ON

Temperature Drift Compensation Flag X is OFF

High Resolution mode status flag X is OFF

Operating condition setting completed flag X is ON

OFFSET/Gain setting Mode Flag X is OFF

Channel Change Completed flag X is OFF

Maximum value / Minimum Value reset completed flag X is OFF

A/D Conversion Completed Flag X is ON

Error Flag X is OFF

Operating Condition setting request Flag Y is OFF

User Range Write Request  Y Is OFF

Channel Change Request Y is OFF

Maximum Value / Minimum Value  Reset Request Y is OFF

Error Clear Request Y is OFF

 

 

Share this post


Link to post
Share on other sites

Strange, Have you contacted Mitsubishi ?

Share this post


Link to post
Share on other sites

No i did not connect mitsubishi.

Previously i just changed my power supply from q61p-A2 to Q64p because there was an error on the PLC error code is 1403 unsupported module is mounted.to resolve this error i replaced my power supply on main chashis with q64p. after replacing the power supply the error 1403 did not occur again but this happened that all my analog inputs modules channel values hold its last value after random time like after 12 hrs or 18 hours.and after power off the plc supply it works normally.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now