HELP WITH ETHERNET COMMUNICATION LOGO8 SIEMENS AND KINCO HMI

[Rodrigo Balsalobre 1]

 Hello!
  I was trying to communicate my siemens logo with an kinco hmi but this error are appearing on the hmi, what am I doing wrong? Im using an ethernet hub!

ETHERNET SETTING ON THE HMI

THE PUSH BUTTON THAT ACTIVATES M1

THE LAMP THAT'S REPRESENT "Q4"

AND THAT I DON'T KNOW HOW ITS WORKS BUT I JUST PUT ON THE SCREEN TO

THE PROGRAM ON LOGO SOFTCOMFORT

I JUST SET THE LOGO AS SLAVE WITH THE HMI IP

THE LOGO IP

AND THE ERROR MESSAGE

[Rodrigo Balsalobre 1]

Wow, the lamp isn't appearing on the hmi for some reason

[dekor 12]

Hi,

You must allow LOGO to be accessible 

 

Go to online settings \ Access control settings  and allow data to be accessed by Ethernet.

I am not sure also about your program, but might be also necessary to add on parallel with your output Q1, an network output NQ1( V0.0 for example). Then you will check in HMI the status of  network output,  respectively status of V0.0

Try those things and let us know your results. 

[Rodrigo Balsalobre 1]

16 hours ago, dekor said:

Hi,

You must allow LOGO to be accessible 

 

Go to online settings \ Access control settings  and allow data to be accessed by Ethernet.

I am not sure also about your program, but might be also necessary to add on parallel with your output Q1, an network output NQ1( V0.0 for example). Then you will check in HMI the status of  network output,  respectively status of V0.0

Try those things and let us know your results. 

I think it's already  allowed, can you help me with that?

And about the program, I just make it equal like this video: https://www.youtube.com/watch?v=-OhAgn4TGBw&t=65s
The guy who made this video takes a while to do it correctly because he make a mistake, but the final result is equals than mine

[Rodrigo Balsalobre 1]

I can to this communication using the hmi as a slave, but with that, its more hard to do what I want, like on the video that I sent, the hmi uses the i/o from plc, using the plc as a master its like that: 

The ethernet connection on hmi software

The type of adress and his number:

How you need to write on plc:

 

  And theres an error with this program, for some reason he stopped to work like yesterday, but I will fix it
  Btw, on this method, it's like i said, it will be more hard to do what i need after this simple logic

 As you can see, theres no error with this method

Edited 8 Jun 2021 by Rodrigo Balsalobre

[Rodrigo Balsalobre 1]

just fixed the problem that i said before, but its using the other method that i tought, It will be nice if uses the hmi as a master like the first method with that error