Sign in to follow this  
Followers 0
Mark-

Mitsubishi FX3u Ethernet options...

4 posts in this topic

Hello,

Is it possible to have a FX3U-ENET module on the right side of the PLC and a FX3U-ENET-ADP on the left side?

If possible, how to specify the module number in FX Configurator-EN?

Regards,

Mark

Share this post


Link to post
Share on other sites
3 hours ago, Mark- said:

Привет,

Можно ли разместить модуль FX3U-ENET с правой стороны ПЛК и FX3U-ENET-ADP с левой стороны?

Если возможно, как указать номер модуля в FX Configurator-EN?

С уважением,

отметка

Depends on which base controller you are using. You can check your build in the online configurator.

https://www.mitsubishielectric.com/fa/ssl/products/cnt/plc_fx/ex/select/fseltool/fseltool.html

60b85f4e880aa_2021-06-03075723.thumb.png

I cannot answer the second part of the question.

Edited by Neverov
1 person likes this

Share this post


Link to post
Share on other sites

The FX3U-ENET is configured via  FX Configurator-EN so it is considered a "special function Module" If it is located right next to the plc it will be Module nr 0 , If you have a FX3U-4AD next to the plc and then the FX3U-ENET it will be module Nr 1 .

The FX3U-ENET-ADP is setup via special relays and registers with Gx developer or Gx works 2.

Refer to manual  JY997D45801 for the  FX3U-ENET-ADP

1 person likes this

Share this post


Link to post
Share on other sites

Neverov and Theuns, thank you.

 

Edited by Mark-

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0