Sign in to follow this  
Followers 0
Mark-

Mitsubishi FX3u with FX3u-ENET configuration...

3 posts in this topic

Hello,

I have an FX3u-16MR/ES, FX3u-ENET (version 1.0), using GX Works2 Version 1.596W (Trial version).

Using FX Configurator-EN (version 1.0), the IP address of the FX3u-ENET is set and I can ping it with success.

GX Works2 fails to communicate with the PLC, via Ethernet, and all other software capable of communication with the PLC fails when using Ethernet.

I read one PDF about creating a new module under “Special Module...”. The only module listed is “AnyWireASLink”. Perhaps that is a limitation of the trial version. The document had “FX3u-ENET-L”. FX3u-ENET and FX3u-ENET-L seem to be different?

Any ideas?

Thanks,

Mark
Edited by Mark-

Share this post


Link to post
Share on other sites

FX3U-ENET and FX3U-ENET-L are slightly different, the -L is a 'lite' unit with less functionality.

I am pretty sure the trial version is not allowed to get online with a controller, at least it wasn't years ago.

Share this post


Link to post
Share on other sites
4 hours ago, Crossbow said:

FX3U-ENET and FX3U-ENET-L are slightly different, the -L is a 'lite' unit with less functionality.

Thanks for the response.

All working now. The "open settings" in the "FX Configuraior" had not be configured correctly.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0