Posted 21 Mar 2021 hi everyone i m traying to write to plc a program and getting this message then program is not downloading to plc 'there is a device in the program (main) that is outside of the range check the program and currect the device that outside of the range ' I m using mitsubishi fx3ga-60mt plc. please suggest me about it . thank you hello everyone please let me know about how to make software tool for password read from Mitsubishi,delta, omron, siemens plc . thank you Share this post Link to post Share on other sites
Posted 21 Mar 2021 hi everyone i m traying to write to plc a program and getting this message then program is not downloading to plc 'there is a device in the program (main) that is outside of the range check the program and currect the device that outside of the range ' I m using mitsubishi fx3ga-60mt plc. please suggest me about it . thank you hello everyone please let me know about how to make software tool for password read from Mitsubishi,delta, omron, siemens plc . thank you Share this post Link to post Share on other sites
Posted 22 Mar 2021 Trying to Hack PLC's will not be supported on this forum !!!! Share this post Link to post Share on other sites
Posted 22 Mar 2021 Trying to Hack PLC's will not be supported on this forum !!!! Share this post Link to post Share on other sites
Posted 22 Mar 2021 We had an issue with a password protected PLC and after contacting the OEM they provided the password that they forgot to remove. But stealing intellectual property is illegal so you may have to factory reset the PLC and remake the program. Share this post Link to post Share on other sites
Posted 24 Mar 2021 Hi Rakesh. Good luck with this enquiry. Especially Mitsubishi is taking the locked PLC very seriously! I have some expirience with the guys and the general rule is, if you don´t have the password, its not your software, we will not unlock it for you ( I am not even sure if they can). Share this post Link to post Share on other sites