Sysmac studio support FINS/TCP?

[sakontanut 0]

Hi all,

I'm a new using Sysmac Studio. I would like to ask for Omron NX1P2 ver. 1.41, Does Sysmac studio support FINS/TCP? 

For what I know the older omron plc like CJ2M I can set FINS/TCP in cx-program. But I can't find it in the sysmac studio. Please give me some advice. Thank you very much.

 

 

 

Edited 8 Mar 2021 by sakontanut

[photovoltaic 121]

The commands you seek are Send and Rcv. Unfortunately though the NX1P2 doesn't support them.

https://www.edata.omron.com.au/eData/NX/W596-E1-01.pdf 

section 1-3

[sakontanut 0]

Thank you Photovoltaic, could I ask one more question. So the issue only NX1P2. If we will use other models such as NX102, NJ series, can we use FINS/TCP?

[photovoltaic 121]

NX102 and NJ both support the commands yes

[hukc 1]

Hi!

You want to use direct FINS messages?

Or you want to read and write the PLC memory via FINS?

If the second you can use NX1P2. Enable the CJ memory and then you can read and write these memory area.

[Michael Walsh 268]

One note on the NX102: only port 2 supports FINS.  

[sakontanut 0]

Thank you everyone for your help. I think I will use Modbus TCP.