scotty134

MC Test Mode was interrupted

3 posts in this topic

Hello guys,

I experience interesting behavior on NX102 PLC. I have an application with NX102-1200 v1.41 and 7 R88*-1S servos in total. All axes were added as a single-axis position. During servo set-up and tuning we periodically experience a communication error. Connection between laptop and PLC over ethernet. Did anybody have similar problem? 

Error message #1:

-MC Test Mode was interrupted in the controller. The MC test run is terminated.

Error message #2 following error:

-A communication error has occurred. 

Share this post


Link to post
Share on other sites

Are there any motion functions being executed in your logic during the test run?

Share this post


Link to post
Share on other sites
On 3/5/2021 at 10:11 AM, photovoltaic said:

Are there any motion functions being executed in your logic during the test run?

nope. All programs with motion commands were detached from the main task.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now