Posted 2 Mar 2021 Dear, I've just started using GX Works and I need to convert an old program made in GX Works2 to GX Works3. I've already solved most of the problems, but the a 'K0' command is not allowed in GX Works3. Current situation: The current step value is compared with ;'K0 ',' K1 'or' K2 ' My question: Is the 'K' value in not accepted GX Works3? Should I use a different value? Share this post Link to post Share on other sites
Posted 2 Mar 2021 (edited) You can just delete the K. K meant decimal value. In GX works 3 it is a decimal value by default. of in andere woorden... Gewoon weg laten die K!!!! Was dat bij importeren niet automatisch verwijderd? Edited 2 Mar 2021 by Gambit Share this post Link to post Share on other sites
Posted 3 Mar 2021 15 hours ago, Gambit said: You can just delete the K. K meant decimal value. In GX works 3 it is a decimal value by default. of in andere woorden... Gewoon weg laten die K!!!! Was dat bij importeren niet automatisch verwijderd? Gambit Duidelijk;) No, it didn't correct it automatically thanks for your reaction! Share this post Link to post Share on other sites