Posted 25 Apr 2022 29 minutes ago, robagRebts said: The firmware is 1.18! Do I need to upgrade? From what I can find the firmware below 1.40 needs a modified ESI file for the EK1100. So I would start there with the new stack. You'll need an Omron Representative to do the upgrade though. 1 person likes this Share this post Link to post Share on other sites
Posted 25 Apr 2022 Thanks for the information, I'll continue the project tommorow! I write if I found some solution (ESI or upgrade). Share this post Link to post Share on other sites
Posted 26 Apr 2022 22 hours ago, photovoltaic said: From what I can find the firmware below 1.40 needs a modified ESI file for the EK1100. So I would start there with the new stack. You'll need an Omron Representative to do the upgrade though. Thank You for the help. I made the firmware upgrade and everything is work fine. 1 person likes this Share this post Link to post Share on other sites
Posted 27 Apr 2022 On 4/26/2022 at 9:51 AM, robagRebts said: Thank You for the help. I made the firmware upgrade and everything is work fine. On 4/26/2022 at 9:51 AM, robagRebts said: Thank You for the help. I made the firmware upgrade and everything is work fine. Good to hear! 1 person likes this Share this post Link to post Share on other sites
Posted 27 Apr 2022 Reading this thread again. What's the reason to use the Beckhoff coupler instead of the Omron ECC coupler? Is this a supply issue? or cost issue? Just curious. Share this post Link to post Share on other sites