NOT AND POT controller by PLC

[hamadi 0]

hello

i have 1S SERVO omron and PLC NX1P2

I want to wire the servo limit switches (POT NOT) to the PLC and send these values to the servo via ETHERCAT

Can i do it if yes how

Edited 25 Jan 2021 by hamadi

[Crossbow 295]

Horrible idea!

You want to wire the POT and NOT to the amplifier!  The amplifier uses them to stop the motion.

The PLC gets them over EtherCAT already from the amplifier.

[BITS N BYTES 66]

2 hours ago, Crossbow said:

Horrible idea!

You want to wire the POT and NOT to the amplifier!  The amplifier uses them to stop the motion.

The PLC gets them over EtherCAT already from the amplifier.

+1

[panic mode 246]

ditto