Posted 9 Dec 2020 (edited) Hi , I need to connect a CQM1H cpu51 with NS12 I m not able to establisn the connection between them. Could you help me. thks Edited 9 Dec 2020 by marc boossy Share this post Link to post Share on other sites
Posted 10 Dec 2020 Assuming you are using a serial connection: - Do you have the correct cable? The cable diagram can be found in the NS Series Programmable Terminals Setup Manual. - CQM1 serial port settings must match NS serial port settings. In CX Programmer, from the project tree, select 'Settings' > 'Serial Port'. - For the NS, in CX Designer.... From the menu, select 'PT' > 'Communication Settings'. You'll need an item under 'Serial PortA'. Set it to 'PLC', 'SYSMAC-PLC". The easiest method is to use 'Host Link'. Default settings (in both NS and CQM1) are 9600, 7, 2, Even. Again, make sure they match. 1 person likes this Share this post Link to post Share on other sites
Posted 10 Dec 2020 Thank you I will try it and let you know. Share this post Link to post Share on other sites