Mitsubishi Q Series Fault Logic

[Kdawg 0]

Im trying to create some rungs to monitor some PLC Faults.  AC Down, I/O Module Fuse, Op Error, PRG time over, Low Battery, Clock Data, StBy Mode, Annuuciators, LED Instructions. However, I cant figure out what logic to use in order to display these faults as the Addressing is limited. Can anyone help? 

[Gambit 324]

What do you mean/want to accomplish ?  All this info is already on devices.

Addressing is limited??? How so ?

Edited 4 Sep 2020 by Gambit

[Kdawg 0]

I’m trying to put in some rungs which will trigger alarms for each of those points. In the manual it states in registers SD 207-SD209? That’s only 3. For 11 different alarms. The manual says it goes by priority but does say when it triggers were it resides. My local rep suggested SD0. But again it’s only one. Would like 11 inputs to trigger 11 (M3000). Can u suggest something? Your help is greatly appreciated 

[Kdawg 0]

This is the logic . Just need addressing for each alarm

[Kdawg 0]

This is what I want to achieve. Just need proper addresses 

[Gambit 324]

AC down = SM53
Blown fuse detection = SM60
Operation error = SM56
PRG.TIME OVER = SD81.B
Battery low latch = SM51
Battery low = SM52

You can find them all in your e-manual viewer PAGE SH080483ENG-PDF470 Appendix 2

[Gambit 324]

You can also just check the error code in SD0

[Kdawg 0]

 kindly thanking Gambit so much! Appreciated the help and information!!