Change PLC model in GX Works 3

[Rolf_Inge 0]

Hello. The project I'm in have decided to switch cpu-model from R04ENCPU to R32. It does not seem possible to change it in the module config / hardware view. I try to delete the old CPU, but cpu module cannot be deleted...

Anybody know?

[Gambit 324]

sure just go to : Project => change module type.

 

 

[Rolf_Inge 0]

17 minutes ago, Gambit said:

sure just go to : Project => change module type.

 

 

Gold! Thanks, worked like a charm.

[Bambos 0]

@Gambit hello, i have a similar issue when the cpu type is not available in the menu. FX5UJ-24MR/ES.
Do i need to add a library to have it available in GXWorks3 ? or need gxworks 3 software update? i'm running on 1.038Q

[FRANK RUIZ 2]

13 minutes ago, Bambos said:

@Gambit hello, i have a similar issue when the cpu type is not available in the menu. FX5UJ-24MR/ES.
Do i need to add a library to have it available in GXWorks3 ? or need gxworks 3 software update? i'm running on 1.038Q

If when you start a new project you dont have it like showing below, you will need to update software.

but you can do it for free, just go to "mymitsubishi" website, if you dont have an account is free.

https://gb.mitsubishielectric.com/fa/mymitsubishi/register

 

 

 

Edited 17 May 2023 by FRANK RUIZ
dupplication of pic

[Bambos 0]

@FRANK RUIZ thank you !   i have found this:   GX Works3 [1.090U] [Licence version]

Is that a "paid" version ?  i had a key for the existing version already added. So logically will be updated using the same license ?

[glavanov 40]

If the current ver. is with valid product ID  GXW3 installer will update it.