4 posts in this topic

Dear All, 

Need your help. I have problem with plc cj2m cpu35. After power trip plc error. Err HE Ip 01..what is mean? plc also connected with one pc using ethernet cable. Any suggestion need to do... 

IMG-20200529-WA0101.jpg

IMG-20200529-WA0097.jpg

IMG-20200529-WA0099.jpg

IMG-20200529-WA0058.jpg

IMG-20200529-WA0057.jpg

IMG-20200529-WA0059.jpg

Share this post


Link to post
Share on other sites

"CPU Unit service monitoring error"

Page 6-26 of Manual W472-E1-13.

In Manual W473: "A CPU Unit service monitoring error will occur in the Special I/O Unit if it is not refreshed every 11 seconds. (The ERH indicator and the RUN indicator on the Special I/O Unit will light.)".

Share this post


Link to post
Share on other sites

The red error lights on the CPU and some of the I/O modules indicate that SIOU refreshing is not being accomplished.

Have you made any changes to the PLC settings?

Do you have a copy of the program?

Do any of the units have check marks [see attached picture]?

This error occurs if SIOU refresh has been disabled in the PLC settings and the program logic fails to perform an SIOU refresh for more than 11 seconds.

 

SIOU refresh.jpg

Share this post


Link to post
Share on other sites

Whoever designed the panel knows nothing about heat or how to follow directions... wireway is millimeters away from PLC providing no room for cooling.  There is a documented minimum airspace required around the controller for proper ventilation.  I doubt the issue is heat related, but it can cause cards to fail.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now