Posted 20 May 2020 Hi All I find my self in the middle of a project where i am required to use 12 sew movigear motor/vsd's controlled over EtherNet IP by a Rockwell 5069-L330ER. I dont have any expirence with these and as such was wondering if any one here has any pointers or better yet, a sample program that i would be able to go through to help teach me. I have gone through the manual however im still a little confused as to some points. I would like to be able to start, stop and control speed, acc, dec ect like i can with a Powerflex 525 if its possible. Trevor Share this post Link to post Share on other sites
Posted 20 May 2020 Did you also happen to watch the two videos on howto connect an SEW to Rockwell? http://www.seweurodrive.com/support/software_result.php?woher=software_result&software_searchword=rockwell&software_produkt=E81&software_gruppe=42&software2=Start+Search Share this post Link to post Share on other sites