Posted 12 May 2020 I have an IAI servo that was sent to us with CC-link protocol. I have never in my life used cc-link and can find very little on the topic on integrating with an Omron CJ CPU. I am curious as to whether this has been done, or is even possible given the protocols Omron works with. And if so, what did you have to do to get the PLC to communicate via CC-link. Thanks in advance for the responses! Share this post Link to post Share on other sites
Posted 12 May 2020 I have never heard or seen anyone using CC-Link with an Omron PLC. I know that Omron does not make a specific device for this. I would try to get EtherNet/IP if possible. Share this post Link to post Share on other sites
Posted 12 May 2020 Send the CC-Link controller back and get the EtherNet/IP version. Share this post Link to post Share on other sites
Posted 12 May 2020 That's what I intend to do. Our customers are highly Mitsubishi based and spec'd this out and that's what the engineers ordered . Was trying to avoid a restocking fee. Thank you guys! Share this post Link to post Share on other sites