Origin Search ORG reversal

1 post in this topic

I have wired, configured  PLC and using ORG I have behavior:

direction CCW and when proximity is ON after while I get signal from z -phase and stop and get origin.  My setup is as below.

I would like to get behavior:

direction CCW, when proximity is ON, change direction to CW and go back. When proximity is OFF I get signal from z -phase and I get origin.

In manual there is such option - "Detection Metod" - Methd 0. - I think

When i set this option drive goes CCW and even it reaches proximity it sill goes CCW until get limit sensor.

What wrong I do?



Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now