Sign in to follow this  
Followers 0
ViníciusCesar

About Fx3u-64ccl and how to config using two FX3U cpu's

3 posts in this topic

Someone can help me how to configure two FX3U cpu's using FX3U-64CCL. 
What software and what software version do I need to use. Wich resistor value to use in both points (110 or 330)?

Anyway, sorry for my bad english and thank for any help.

Share this post


Link to post
Share on other sites

There are 3 software packages, you could use any of them.  GX-Developer, GX-Works2, and GX-Works3 are all capable of programming FX3U.

Resistor is dependent on cabling, as indicated in the manual.

Share this post


Link to post
Share on other sites

     Vinícius,

      Just adding a comment to Crossbow reply, currently 110 Ohms cable type is more common. I don't know if you already purchased the cable but, just in case, in Brazil you can find CC-Link compatible cable from Igus (Jundiaí) and Eurocabos.

      If you need help in Portuguese, Mitsubishi Electric Brazil has a technical support address cat@mitsubishielectric.com.br where you can send your doubts.

       BR,

       Thiago

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0