Posted 12 Mar 2020 dear All, I faced a problem that is password problem.I give a password on my fx5u Plc Couple of month ago.but I can't memorize this password.Have any Option Reset Data?i cant communication with plc.every time ask remote bpassword.Please Give the solution Share this post Link to post Share on other sites
Posted 12 Mar 2020 You still have the program right. Than you can clear the PLC via Online - PLC Memory Operation - CLear PLC memory After this the PLC is again in factory settings Share this post Link to post Share on other sites
Posted 12 Mar 2020 i didn't connect with plc.need remote password.if i can communication successfully with PLC then i can reset the password as per your Suggestion .But I can't connect with plc.pls give me solution Share this post Link to post Share on other sites
Posted 12 Mar 2020 It won't ask you for the password when you clear the PLC. If you don't have the original program on your PC than we cannot help you. 1 person likes this Share this post Link to post Share on other sites
Posted 12 Mar 2020 it was blank program.only i put password for check purpose.but password forget. Share this post Link to post Share on other sites
Posted 9 Sep 2020 On 11.03.2020 at 0:52 PM, Gambit said: It won't ask you for the password when you clear the PLC. If you don't have the original program on your PC than we cannot help you. I have FX5U and when I try to open CPU MEmory Information, it ask me for a password. Is It another option to make factroy reset in this CPU. Share this post Link to post Share on other sites
Posted 9 Sep 2020 (edited) But it should not when you press initialization. Updating the firmware might also clear your PLC program:https://www.mitsubishielectric.co.jp/fa/download/software/detailsearch.do?mode=software&kisyu=/plcf&shiryoid=0000000051&lang=1&select=0&softid=1&infostatus=8_1_1&viewradio=1&viewstatus=&viewpos= Edited 9 Sep 2020 by Gambit Share this post Link to post Share on other sites
Posted 9 Sep 2020 When I try initialization it also ask for password. I tried updating firmware, but the password is still set, also plc IP adres is the same. Share this post Link to post Share on other sites
Posted 9 Sep 2020 That is strange it shouldn't. Have you tried updating the firmware ? Share this post Link to post Share on other sites
Posted 9 Sep 2020 Yes I tried updating firmware, but during this procedure PLC make BCK of program on SD card, and dowloand it after updating. Share this post Link to post Share on other sites
Posted 9 Sep 2020 I found a solution. You must stop the procedure halfway Pun in SD card with new firware Turn on PLC Reset PLC Wait until run and error stop blinking Turn off PLC nad put out the SD Card After that PLC uptade the firmware but don't dowland the BCK program from SD card. Share this post Link to post Share on other sites
Posted 8 Jul 2023 Hi Filips... About your fx5u password problem, Did you get the solution out already? please let me know. thanks Share this post Link to post Share on other sites