Posted 20 Feb 2020 Hi all, I am trying to configure an Fx3ge-24M PLC using GX-works 2. I can successfully connect to the PLC using the USB cable, however i am having trouble getting a connection via ethernet. I have attached a photo that contains the only ethernet configuration that i can find, what am i missing here? I'm new to GX works & mitsubishi PLCs. Share this post Link to post Share on other sites
Posted 20 Feb 2020 Try entering a subnet masking of 255.255.255.0 and default gateway of 0.0.0.0. Then check that your PC is in the same subnet with a different IP address. Share this post Link to post Share on other sites
Posted 21 Feb 2020 (edited) also make a melsoft connection in the open settings for ethernet If you still cannot connect also post your transfer settings Edited 21 Feb 2020 by Gambit Share this post Link to post Share on other sites
Posted 21 Feb 2020 Create some setting in transfer setup connection. Share this post Link to post Share on other sites
Posted 21 Feb 2020 did you create the melsoft port in the open settings and download it into the plc ? Share this post Link to post Share on other sites
