Posted 10 Feb 2020 Good day, how can I communicate with SMC EX600 by Ethernet/IP have you any exemple? I do a setup by EIP configuration tool and write into EIP module but I cant switch any bit into EX600. Thanks Share this post Link to post Share on other sites
Posted 10 Feb 2020 Contact SMC tech support, they have their own Bootp/DHCP tool. After that you'll need to config the PLC Input, Output and Configuration Assemblies. 1 person likes this Share this post Link to post Share on other sites
Posted 10 Feb 2020 Thx for reply, but configuration is ok, but i dont switch any bit or get status in plc, or send bit t9 switch any solenoid Share this post Link to post Share on other sites
Posted 10 Feb 2020 Post your program and one of the true Mitsubishi experts will look it over. Share this post Link to post Share on other sites
Posted 17 Feb 2020 Thanks all the problem is solved. EDS file for SMC EX600-SEN3 have bad parameters after correct unit run perfectly. Share this post Link to post Share on other sites
Posted 21 Nov 2020 Hi Zpassha, I having same problem. how you fixed it? could you explain? I'm trying to fix the input and output bytes but I'm not sure if I in correct way. Thanks in advance Share this post Link to post Share on other sites