Posted 5 Feb 2020 Good day Guys I have been working with Mits for a while but i am new to the GX works 3 setupp. We are looking at using R08SFCPU PLC with a RJ71GF11-T2 for CC-Link IE Field in order to do safety. No i think i understand the normal IO on this device but the safety i just cant get to a point to understand what is happening. When i try to address it SA\X0.... then it says it is invalid. Does anyone have an idea how to do the setup for safety or a manual that describes a bit in detail. Thanks Share this post Link to post Share on other sites
Posted 6 Feb 2020 Did you follow the safety iQ-R trainging(e-learning) https://www.mitsubishielectric.com/fa/assist/e-learning/eng.html#en_bg Share this post Link to post Share on other sites
Posted 7 Feb 2020 Good day. Thanks for the reply i did not know about this i will have a look. Much appreciated. Share this post Link to post Share on other sites
Posted 7 Feb 2020 22 hours ago, Gambit said: Did you follow the safety iQ-R trainging(e-learning) https://www.mitsubishielectric.com/fa/assist/e-learning/eng.html#en_bg Thanks for the reply. i still get the following error. Share this post Link to post Share on other sites
Posted 7 Feb 2020 Sorry for the silly question, but do you use the right label list category? When you create a new label list you can modify it's category to safety. Share this post Link to post Share on other sites
Posted 7 Feb 2020 1 hour ago, tosza93 said: Sorry for the silly question, but do you use the right label list category? When you create a new label list you can modify it's category to safety. Not a silly question i was not thinking it through. If you use the standard you can X and Y, and when you do safety you can do SA\X and SA\Y. But if you use the Standard/safety shared is when the error occurs. plus i found a manual that assist a bit better with the setup and programming It is Melsec IQ-R Safety Application Guide in the e-Manual Viewer. Will start coding now and by next week we will have the CPU's to start testing. to see if i understood correctly. Thanks for the assist. Share this post Link to post Share on other sites
Posted 7 Feb 2020 hello to use the variables you have to do the safety table, I attached an image of the three tables, shared safety, no safety, and only safety so I could see the table that is putting the safey entry, it is a non-safety table Share this post Link to post Share on other sites