Posted 28 Jan 2020 (edited) Hi! I have a question about programming. I want to place an input (X01) on the left vertical line, to allow the rest of the program running by an external switch. How can I place an input like that? I work on Gx works2 and using an Fx3g Plc (I used it once, but i can't find that program.) Edited 28 Jan 2020 by Gman1 Share this post Link to post Share on other sites
Posted 28 Jan 2020 Look into the MC and MCR commands. Those are the Master Control and Master Control Reset commands. They will essentially allow you to enable a whole block of logic that is contained between the MC and MCR. Share this post Link to post Share on other sites
Posted 28 Jan 2020 | X0 | ----- [MC n1 M0] Stuff to run when X0 is on.. ---------------[MCR n1] Stuff that runs all the time Share this post Link to post Share on other sites