Posted 23 Jan 2020 Hi, I have an Array of 120 DINT's, 120 positions. Each Index of a Dial equates to One DINT (position), and if a bad part is detected then a "1" is put into this DINT, good part is "0". The DINTs are cleared after each full revolution of the Dial. What that I am trying to check to see if a "1" is put into any of these, i.e. a bad part. I was trying to use a FSC Instruction, but I haven't used before, and would be grateful of some help with this. Thanks Conor Share this post Link to post Share on other sites
Posted 23 Jan 2020 http://www.plctalk.net/qanda/showthread.php?t=1354 The above thread may help you out. Regards, Garry Share this post Link to post Share on other sites