FSC Instruction

2 posts in this topic


I have an Array of 120 DINT's, 120 positions. Each Index of a Dial equates to One DINT (position), and if a bad part is detected then a "1" is put into this DINT, good part is "0". The DINTs are cleared after each full revolution of the Dial.

 What that I am trying to check to see if a "1" is put into any of these, i.e. a bad part. I was trying to use a FSC Instruction, but I haven't used before, and would be grateful of some help with this.

Thanks Conor

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now