jg0825

how to add fx3u-2hc to fx5 module configuration diagram in gxwork3

5 posts in this topic

hi, 

I need to add a fx3u-2hc module to fx5 plc system. In gxwork3 I can find the fx5-cnv-bus module. But how can I add the fx3u-2hc after fx5-cnv-bus? Please help me out . Thanks.

Share this post


Link to post
Share on other sites

Actually this FX3U module will not appear (no way to add) in GXW3 hardware configuration, you just add the FX5-CNV-BUS and the FX3 modules that go after should be directly addressed in the program using TO/FROM instructions or U\G devices.

Don't forget that the FX5-CNV-BUS consumes one address, so the FX3U-2HC must be addressed as CNV address + 1.

Thiago

Share this post


Link to post
Share on other sites

Hi,

 

Does anyone have a example program of setting a high speed counter up through the CNV using the FX3u module?

Morne

Share this post


Link to post
Share on other sites

Hi there,

I am in the same boat.  Needing help with this setup as jg0825.

Appreciate any experts advise.

Thanks!

Regards,

Thomas

Share this post


Link to post
Share on other sites

The answer was already posted, read Thiago's message.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now