MikeHiggz

L Series PLC/LJ71E71-100/ Modbus TCP

4 posts in this topic

Hi,

I am using a L-Series PLC with a Ethernet Card (LJ71E71-100). I need to add communication in a simple project between this L-Series PLC and a Rexroth Tightening System (CS351).

The Tightening Ssytem has a Modbus Network Card which is configured for a known ip address. 

My difficulty is setting up the PLC to communicate with the external device. As reference i have been using  No SH081105ENG-222 manual Section 11. I have been attempting to setup a predefined protocol, however i am confused by the example program shown in sectrion 11.5.3.

Any advise or help with this would be massively appreciated.

Share this post


Link to post
Share on other sites

What are you confused about ?

 

Share this post


Link to post
Share on other sites

Morning Gambit,

The example shows connection via SLMP instead of Modbus TCP. I am confused with the difference i need to make to the example program.

Cheers,

Share this post


Link to post
Share on other sites

Forget SLMP that is a Mitsubishi driver. you'll should define a pre-defined protocol port.

Are you using the PLC ethernet port or de module ?

 

Edited by Gambit

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now