CCW/Micro800 series

[grubb 1]

Hello all!

I have a two part question - both revolve around using Rockwell's CCW software.

1) in rs500 you can mov a value into the an int memory slot and call that int up later on for comp. instructions to see where you're at. Example, if x switch is active, mov value 0 into N7/0. If y switch is active, move value 1 into N7/0. If both x & y are active, move a value of 2 into N7/0. How is this done in CCW??? I've found the mov command but not sure where/how to store this value.

2) How do does one shot [ONS] work in CCW?!? From what I've gathered the r_trig and f_trig is its replacement, and thought it made plenty of sense. But no matter what I do the triggers never work out correctly.

Thanks,

-g