Posted 17 Mar 2019 Hi gents. I am new at this forum. I need help for establish connection PC to CP1L-M. I try to connect whit normal USB cable but I can not establish connection. Driver for USB is installed and its visible in device manager when I connect USB cable PC to PLC. Also I try to connect via serial connection using RS232/USB converter but without success. Is there any trick for establishing connection whit Omron CP1L-M PLC? Share this post Link to post Share on other sites
Posted 17 Mar 2019 Hi. Already I done that, but its not going. Is there any trick for connecting PC to PLC, like dip switches (already SW4 was on during RS232 connection but no success). What is procedure for c connection, what is RS232 cable pin out, what cable I need to use? 1 person likes this Share this post Link to post Share on other sites
Posted 18 Mar 2019 Cable pin out for RS-232 connection: GTC99CC.pdf 1 person likes this Share this post Link to post Share on other sites
Posted 19 Mar 2019 On 18/03/2019 at 9:37 AM, gtsuport said: Cable pin out for RS-232 connection: GTC99CC.pdf As gtsuport says, I make RS232 cable with pin out as attached file and used whit serial/USB converter. Finally connection PC>PLC was established, but... project is protected by password. So, now, next step is to contact company which made project for this PLC to get password. Share this post Link to post Share on other sites