Posted 11 Feb 2019 hallo everyone ...i use mitsubishi Q00UJCPU and QD77MS2.. i try to make a speed control program and the speed wants to be changed during servo operating, i use dedicated instructions ZP. PSTRT1 (axis 1) and have tryed but it was only successful to change speed with "change speed control" function once ... is it like it? cannot change "change speed control" many times when servo operations? Share this post Link to post Share on other sites
Posted 11 Feb 2019 Did you turn off/reset speed change request signal after completion of that function? Share this post Link to post Share on other sites
Posted 11 Feb 2019 23 minutes ago, glavanov said: Did you turn off/reset speed change request signal after completion of that function? yes sir I use this ladder to reset after i use speed change Share this post Link to post Share on other sites
Posted 11 Feb 2019 Who RST M502? Your MOVP instruction will not work again with M502 on Share this post Link to post Share on other sites
Posted 11 Feb 2019 Just now, glavanov said: Who RST M502? Your MOVP instruction will not work again with M502 on I have been careless sir, so thx you @glavanov, you already reminded me Share this post Link to post Share on other sites