1 post in this topic

Once again. I'm still facing problem with Pofibus communication between PLC and Comnet-DP module.

I'm trying to connect Bosch valve station equiped with Comnet-DP communication module with Omron CJ2M and RPM21 (profibus master)
I've made proper configuration in master settings (most important was baud rate but Bosch module adjust baud according to master)

Then I've set slave configuration as you can see below:1.thumb.JPG.081b298c920cf9ada2121b0fbcdd

2.JPG.f535207e0253a95946848acd35a5bf56.J

3.JPG.f4f8dbb220955ca72be0eecc645596de.J

According to:

4.JPG.de48ed6f24f2441004d3afb12750b8c6.J

 

Other settings were unable to modify or just were left unchhanged.

Omron is detecting connected slave but returns diagnostics that says that something is wrong in parameter settings. Same message I can read from Bosch module LEDs.

5.JPG.f3da6b16270705e346f07ec4db52d17b.J

6.JPG.d125d497a6b04a6912df8c77658b5a20.J

Any experiance in profibus diagnosis, advices what to do? I've checked all settings configurations I have no idea what to do.

 

6.png

 

 

 

Edited by malyalewariat

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now