Posted 13 Jan 2019 Is there any function for Mitsubishi PLC to perform as a Modbus Slave? Share this post Link to post Share on other sites
Posted 13 Jan 2019 Hello Myint Than Zaw. What type of modbus are you intending to use? Mitsubishi Q do support the use of Modbus Serial and Modbus TCP. Regards Daniel. 1 person likes this Share this post Link to post Share on other sites
Posted 14 Jan 2019 (edited) Hello Daniel I will use QJ71MT91(TCP IP) as a modbus slave to sent information. Is there any sample for this? Edited 14 Jan 2019 by Myint Than Zaw Share this post Link to post Share on other sites
Posted 14 Jan 2019 (edited) See here for documentation. http://www.mitsubishielectric.com/dl/fa/document/manual/plc/sh080446eng/sh080446engh.pdf Initial settings such as the IP Address can be set in the intelligent module setup utility, what software are you using? This module also requires initial logic to start/stop cyclic operation. Regards Daniel Edited 14 Jan 2019 by collinsd70 1 person likes this Share this post Link to post Share on other sites
Posted 14 Jan 2019 Thanks Daniel I got it. It can work. I am using GX work 2. Thanks. Share this post Link to post Share on other sites
Posted 14 Jan 2019 Glad I could help. Come back to us if you have any further issues. Regards Daniel. Share this post Link to post Share on other sites