Wasan

QJ71C24N CH2 Echo back for MODBUS RTU Predefined Protocol

4 posts in this topic

Hi

I have some problem about QJ71C24N with Modbus RTU Predefined Protocol.

I have setting predefined protocol for QJ71C24N and use 485 wiring to modbus slave but when I start communication it returns CRC error

then I use Circuit trace to check communication that result as in attachment that there are some echo back from send command mix with response command from slave device

I think with these response cause crc error because there are some echo back in response data

I have setting echo back to prohibit but result are same.

How can I solve this problem?

 

Q_Serial_Trace_M_01.jpg

Q_Serial_Trace_M_02.jpg

Q_Serial_Trace_M_03.jpg

Share this post


Link to post
Share on other sites

I have some more information that My PLC product information is not support disable echo back function as in picture below

If anybody have CPU please test about it to find that it is about PLC product information version.

Thank you

Q_Predefined_Protocol_01.jpg

Q_Predefined_Protocol_02.jpg

Share this post


Link to post
Share on other sites

I have solve it by I write echo back (1C2H) parameter to 1 for prohibit echo back on port RS-485

After disable echo back data communication is good as shown below.

Q_Predefined_Protocol_03.jpg

Q_Predefined_Protocol_04.jpg

Q_Predefined_Protocol_05.jpg

Edited by Wasan

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now