Posted 24 Aug 2018 Hi I prepared test application (attachment) and all the time when I start Runtime I get error: "Failed to initialize communication processing. Exit the application except Run and re-start the system." I think I did everything correct. Below my specs. CX Designer 3.730 NS Runtime 1.30 NS Runtime is on PC WIN7 64 bit res. 1024x768 Maybe you can help to find the problem test3.7z 1 person likes this Share this post Link to post Share on other sites
Posted 3 Dec 2019 please attach picture sir, may i help you Share this post Link to post Share on other sites
Posted 22 Nov 2021 Im also having the same issue, is there any resolution? Share this post Link to post Share on other sites
Posted 30 Nov 2021 Same here. I uninstalled CX-Server and and NS Runtime and then installed NS Runtime and then CX Server. CX Server is now looking for the update file CX-Server Version Upgrade Software 2021.01_0401.msi I point it there and it says its not the correct one. I try and run the update separately Svr2101_0401Setup.exe and get later version installed. Share this post Link to post Share on other sites
Posted 7 Dec 2021 I have spoken with the Omron Engineer and after trying a few things i uninstalled CX One and Sysmac Studio, ran the clean up tool and then reinstalled both and the updates and still had the same issue. I then created a new project in CX Designer and removed the Serial A Connection and then this time it worked (it tried it before the reinstall and there was still an issue). It could have been a miss match of CX Server versions. I am yet to try it on a standard machine without any other Omron software installed so will let you know how that goes when i get onto that task. Share this post Link to post Share on other sites
Posted 7 Dec 2021 I have NS Runtime working with a CS1 and and NX1P2 on my Windows 7 64bit machine with CX One, Sysmac Studio and NS Runtime V1.3. The Runtime Project needs to be the latest version 8.1. The Serial A Host needs to be removed - this causes the initial error when runtime starts. The NX1P2 needs to be setup with as SYSMAC-CS1/CJ1/CP1 with Ethernet/IP as the Protocol and the PLC's IP address. I am using the CIO addressing so this needs to be enabled in the NX1P2 Memory settings. If you set the NX1P2 as a CJ2 it will timeout. I also setup a CS1 PLC with the same settings. Share this post Link to post Share on other sites