QD70P4 And Servo Driver MR_J4_20A

NgoHoang · 16 Dec 2017

Dear all!

I'm facing a issue when I connect PLC Mitsubishi Q06UDV (use QD70P4 position moudule) vs Servo Motor MR_J4_20A.

Now, Servo motor can run with MR Configuration 2 but not run with QD70P4 module.

Any one have worked with them, please help me about this.

This is wirng and config for QD70P4 + ServoDriver.

Thanks and best regard!

Edited 16 Dec 2017 by NgoHoang

Gambit · 20 Dec 2017

your limit switches are on. Have you set them up for negative or positive logic?

Are you getting any error when trying to drive the motor?

2 posts in this topic