Posted 12 Mar 2017 (edited) Hello every people, I am working in to project with one PV Plus 1000 (2711P-B10C4A1 with Logic Module 2711P-RP1A), one KF2 and PLC 5/15, I have finish logic of PV 1000 and PLC 5, but the communication not good , this is the configuration made: NODOS PLC 5/15 have address nodo 11 KF2 have address nodo 60 PV Plus 1000 have address nodo 0 PINOUT CABLE DB9 (PLC) -- DB15 (KF2) 1--5--7 ---> 8--6--7 DB9 (PV 1000) -- DB25 (KF2) 2--5--3 -----------------> 2--7--3 I wait for your help Thank you Edited 14 Mar 2017 by fernando picture bad Share this post Link to post Share on other sites
Posted 12 Mar 2017 (edited) From your pictures, I notice that the Shortcut is pointed at the DF1 port. Next thing is that in one picture the PV+ is Node 0 and in the other it is Node 15, not a big deal, but the you will need to correct node number to transfer the MER. First make sure you are looking at the "Design (Local)" tab, then highlighting the 5/15 and "Apply". Then press the "Copy from Design to Runtime". Create your MER at the matching firmware level of the PV+. Then transfer it, making sure to turn on the radio button for replace runtime communications. Edited 12 Mar 2017 by pcmccartney1 Share this post Link to post Share on other sites
Posted 14 Mar 2017 the problem continue, help me please the address is correct and conection of cable is correct? Please, see configuration in Serial DF1 properties, is correct the current is this picture in the PV 1000, this is my configuration current in the network but the communication not good with the plc 5/15 and PV1000, In my PC (COM 1) with the RS LINX classic I can see KF2 (nodo 66) and PLC5/15 (nodo 11),but not i see KF2 (nodo 60) and PV 1000 (nodo 0) Share this post Link to post Share on other sites