micrologix 1400 and Pansonic GT707

[AndrewM2112 1]

Anyone else combine the Panasonic GT707 touch screen to a Micrologix 1400? DF1 Serial 9600,n,1

Getting all kinds of intermittant com errors on the screen, has anyone else had a problem

 

[kaiser_will 65]

Micrologix 1400:  D-Sub communication port supports protocols DH-485, DF1-Full, DF1-Half, DF1 Radio, Modbus RTU, ASCII, DNP3 Slave.

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1766-um001_-en-p.pdf

Panasonic GT707 HMI:  D-Sub communication port supports protocols MEWTOCOL & MEWTOCOL7, General purpose serial (for Panasonic dedicated protocol), Modbus RTU, Other.

https://www.panasonic-electric-works.com/cps/rde/xbcr/pew_eu_en/mn_gt707_hardware_jp_en.pdf

It appears there is no defined DF1 protocol for the Panasonic HMI to communicate with any Logix PLC.  You do have the ability to configure communication for Modbus RTU.

[AndrewM2112 1]

The GT707 does apparantly support DF1 (its listed in other)

 

[jesusrubio 0]

i try using micrologix 1500 with panasonic GT707 , when i use CRC  in plc  , the HMI is working good , but when i use BCC i dont have comunication ,then , when i can not modify inside PLC error configuration BCC to CRC ( when PLC is lock by  password).