Posted 9 Oct 2016 Hi all, I would like to monitor the status of my alarm word (MW100) and if any bit turns from 0 to 1 then an alarm signal should be generated, am new to siemens plc and am having a tough time accomplishing this easily. In omrom CX programmer its quite easy to do. Could anyone help me on this using ladder logic, all help will be deeply appreciated. Regards, Ablex PS: I'm using Step 7 V5.5 Share this post Link to post Share on other sites
Posted 10 Oct 2016 Something like this? Not sure on your alarm application. Are you just wanting to trigger a bit? Link to the alarms on a HMI? Share this post Link to post Share on other sites
Posted 10 Oct 2016 I have tried something as below the issue i have is that for memory bit M100.0-100.3 am able to get the alarm response but when i trigger M100.4-100.7 the alarm does not trigger. Share this post Link to post Share on other sites
Posted 11 Oct 2016 What populates the bits of MW100? Why are you trying to convert it from a BCD to an integer? Share this post Link to post Share on other sites