b8203008

About CPU331 PLC Fault Table And IO Fault Table

7 posts in this topic

Dear All

About PLC Fault Table

are there in the %R? where is the addressing?

Thanks

So  i am new 

Share this post


Link to post
Share on other sites

In the CPU331 the "Fault Table" is in protected memory controlled by the Operating System of the CPU. One can 'read' this "Fault Table" with Proficy Machine Edition software. 

Some of the faults can be read by the logic and stored to %R registers, but that needs to be programmed in via Logic and 'Service Request 15' (SVC_REQ 15).

 

Share this post


Link to post
Share on other sites

Thanks RussB

Could I read plc fault table and io fault table from ni opc server?

Share this post


Link to post
Share on other sites

hello, can  some one will tell me how to recover from emergency stop from abb robot.

is there faulty in pliz relay. because i checked in pliz software there  was some faulty errors. but now it is reseted.

if there is prob. with plc allen bradly micrologix 1200. guide me please.  

 

thank you

Share this post


Link to post
Share on other sites
16 hours ago, b8203008 said:

Thanks RussB

Could I read plc fault table and io fault table from ni opc server?

I think not but I do not know what the "ni opc server" is so maybe?

 

Share this post


Link to post
Share on other sites

Thanks RussB

now I have Labview and Labview OPC server !!

Could i use these tools to get Fault Table (PLC or IO) ?

 

Thank so much

Share this post


Link to post
Share on other sites

You should ask Labviw.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now