Delta HMI and program simulation

[Pyrus 0]

Hello, I'm new to Delta PLC, and I would like to know if it is possible to simulate WPLSoft v2.41 program with DOPSoft program. Both belong to Delta (evidently), but I wish to simulate both of them. 

For example: If I press the "On" button (addressed to X0), I want that status to change from 0 to 1 or 1 to 0 (depending if it's normally open or closed) in the WPLSoft Simulation.

I also have ISPSoft, again from Delta, and again, I do not know if it supports HMI and program code simulation on PC (without the devices)

I'm actually used to Siemens (TIA Portal) and its configuration, and in that integrated development environment, what I stated above works. I just don't know if it works with Delta. If it is possible, please tell me how to simulate because there are no videos about it directly explaining how this is done.

[peyman1365 0]

in a project we should control 24 AC drive(VFD-B), 12 drives connect to one SE plc via modbus serial and other 12 drives connect to another SE plc via modbus serial and 2 SE plc's connect to one SA2 plc+Ethernet module via Data exchange which configured in Delta DCI-SOFT software, the registers and coils collect in master plc(SA2) and i can visit them in plc master(SA2) in WPL-SOFT(online mode) but we have a SCADA software from Schneider company clear SCADA and when we set scanners to tag collected data in clear SCADA for 6 drive every thing is normal but when we set more scanners,scanner stat change to offline we set 3 scanners for each drive and we have only 10 registers and 16 coil for each drive,my question is the problem is for master plc( DELTA DVP-SA2) or from SCADA?

[RuzzaAntonio 0]

https://youtu.be/ZZI0J1es3LUQ

Maybe this video with the sub can help