nguyenthucuc

Q172CPUN and MR-J2M to control position

4 posts in this topic

Hello Dears,

I am studying to control position via Mitsubishi device

Now, I have Q172 CPUN and MR-J2M(MelServo) to control position.

But, I didn't find manual that explain command and parameter to do it and it has the example to do it.

who have experience to control position, pls help me to overview it.

Thanks so much!

Share this post


Link to post
Share on other sites

There are a series of manuals for the Q172CPUN.  And that processor programs in MT Developer.

You need to write code in the PLC with GX Developer and then code in the Q172 with MT Developer.  Parameters need to be set on both units to match, and they have to be installed on the rack side by side in the CPU and slot 0 spots.

It's too complex to explain in a post, you need to find the manuals and read up on it a bit.

Share this post


Link to post
Share on other sites

Thanks Crossbow,

I also finding and study about it, but not really clear about it.

Do you have  MT Developer  software and can you share it for me

 

Share this post


Link to post
Share on other sites

Nobody can share it with you.  You must buy it from Mitsubishi.  Software piracy is illegal.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now