Chris Iwo

CitecSCADA to Rx3i Communication Setup

6 posts in this topic

Hi All,

I am trying to setup the communication between GEIP PACSystems Rx3i and Schneider Electric CitecSCADA 7.1

Does anyone have the procedure?

Thanks

Chris

Share this post


Link to post
Share on other sites

What choices of communications drivers are available in Citect? If Citect does not include a specific GE driver, the Rx3i can also be configured for ModbusTCP.

Share this post


Link to post
Share on other sites

Most of the RX3i Ethernet ports are OPC UA Client & Server compliant too.
Via other port options most can also communicate DNP3 and Hart.

 

Share this post


Link to post
Share on other sites

it depends on type of rx3i CPU, you can also add additional ETM card and use ethernet IP protocol as standard. add the same IP in citect scada.addresses are %i %m%mw(%r)

Share this post


Link to post
Share on other sites
23 minutes ago, Sai Krishna said:

it depends on type of rx3i CPU, you can also add additional ETM card and use ethernet IP protocol as standard. add the same IP in citect scada.addresses are %i %m%mw(%r)

One can add an IC695ETM001 module to any open slot in the CPU rack on a RX3i system, however.

I think he means GE SRTP or the EGD protocol no GE processors or modules communicate 'Ethernet IP' today.

Edited by RussB

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now