Posted 25 Dec 2015 Dear Experts!!!! Can you tell me the complete clear cut procedure of PIDE autotune functioin And plz tell me when i shoukd do it ??? I.e. when the set point near the actual or when its far away and reaching to the SP. Can't i do it in FBD in Auto mode : If yes then how??? Have to put FBD Block in manual mode always???? Any other way to autotune it??? Share this post Link to post Share on other sites
Posted 29 Dec 2015 Have you read up on the PIDE function block? This should help. http://www.plcdev.com/getting_started_with_the_logix5000_pide_function_block https://cours.etsmtl.ca/gpa754/references/fabricants/Logix_Complement/pide_autotune.pdf http://literature.rockwellautomation.com/idc/groups/literature/documents/wp/logix-wp008_-en-p.pdf http://www.plctalk.net/qanda/showthread.php?postid=84553#post84553 Share this post Link to post Share on other sites