XW2Z 24 Pins connector standard?

[angeraer 1]

Hello, I'm looking for some additional Omron cables (XW2Z + terminal block). I was wondering if the 24-pin connector used on an ID215 or OD215 module is something 'Omron' specific or an open standard? I would like to create them myself because they are quite expensive. Thanks, Andy.

[Crossbow 295]

I'm looking at CJ1W cards and don't see an ID215 or OD215. Which PLC are you talking about?

[BITS N BYTES 66]

These are for a C200H PLC. These cables COULD be made up using flat ribbon cable and an IDC connector at each end. PLC connector is a FUJITSU FCN-367 and terminal block a standard MIL rectangular socket the other end. Personally I wouldn't waste my time doing this. Got better things to do and cable cost is small compared to complete PLC Rack. My 2.07496 cents. OMRON Cables for Relay Blocks.pdf