Sign in to follow this  
Followers 0
vodoca

STP NIP 2212 - how long are output values persisted after network error

4 posts in this topic

Whe have STB NIP 2212 with DDO3705 connected via optical ethernet with Modicon Momentum M1 PLC. When I disconnect ethernet cable from STB NIP 2212, the machines connected to DDO3705 go off immediately. Is there any option how to configure, how long are output bits persisted, similarly like on ENT 110 01? There I can setup 0 (indefinitely) to 60 seconds. Edited by vodoca

Share this post


Link to post
Share on other sites
Hi vodoca, you can choose between fallback mode and hold last value and set timeout for some DDO via web browser. Just login with webbrowser to your NIP and set this settings. Edited by Quant
1 person likes this

Share this post


Link to post
Share on other sites
Yes, thanks, found it too after all, but on older NIP with exec version 2.0.2 there was in the web interface no choce for "Link failure mode" - does it mean it is "Holdup" by default? On 3... firmware I have setup Link failure mode "Holdup" and 5000 for 5 seconds.

Share this post


Link to post
Share on other sites
normally, the default value is "Fallback mode", so that after link down all outputs going to 0.
1 person likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0