Sign in to follow this  
Followers 0
Guest Guest_Steve Cheung

Ethernet module for Mitsubishi PLC FX2N

4 posts in this topic

Dear All, Anyone know where I could find the Ethernet Module for use with Mitsubishi FX2N PLC? Thanks & best regards Steve

Share this post


Link to post
Share on other sites
The unit you are looking for is a COM-10ET-T ethernet interface for FX series, I believe that the unit is available in Europe the a previous thread discussed this FX Ethernet The manual is also attached for info. Regards fx_com_et_10_t.pdf

Share this post


Link to post
Share on other sites
This is available in the usa: FX2NC-ENET-ADP

Share this post


Link to post
Share on other sites
The FX2NC-ENET-ADP is new to the US, but it will allow you to connect an FX1S/FX1N/FX2N/FX2NC to Ethernet. Keep in mind it is a serial to Ethernet adapter, connects to the serial extension port on the LEFT of the CPUs, and in the FX1N/FX1N/FX2N requires a converter board to connect to PLC. If you're already using a board, you can't use this module. Another note, it requires a virtual com port driver on your PC, to assign an IP address to a COM port. COM-IP from Tactical Software is the recommended solution.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0