Posted 3 May 2015 Hi all: I want to know when the pls2 command has finished to send the pulses. Is there a flag (Axxx.xx) that tells me when it has finished. I had not found any in the manuals I have. Thank you for your help! Share this post Link to post Share on other sites
Posted 3 May 2015 Check the bit assignments for A280 and A281. They correspond to the two pulse outputs. Share this post Link to post Share on other sites
Posted 3 May 2015 (edited) It is right there in the manual!! A280.03 = Pulse Output 0 Output Completed Flag = ON when the number of output pulses set with the PULS(886) or PLS2(887) instruction has been output through pulse output 0. Cleared when operation starts or stops. OFF: Output not completed. ON: Output completed. A281.03 = Pulse Output 1 Output Completed Flag = ON when the number of output pulses set with the PULS(886) or PLS2(887) instruction has been output through pulse output 1. Cleared when operation starts or stops. OFF: Output not completed. ON: Output completed. Edited 3 May 2015 by BITS N BYTES 1 person likes this Share this post Link to post Share on other sites
Posted 4 May 2015 Thank you!!! Which manuals do you use? Edgar Share this post Link to post Share on other sites
Posted 4 May 2015 The details of the A area assignments are in appendix C & D of the W462 manual. Share this post Link to post Share on other sites